Some time ago, I blogged about a digital readout (DRO) I was working on for my Sherline mill. Work on the Elevator project caused that to go on hold, but I finally got back to it and completed it. Mostly, I needed to design and 3D print a case for the interface board and PSoC KitProg. As you can see in the photos, that got done and the whole thing is now complete. I like it a lot as it is much easier to see than the original Sherline unit. Only thing I don’t like is the way the cord is attached at the display unit. I need to modify and reprint the display case so the cord has better strain relief.